LIGHTS TO GO!
  G5 Sequence Animation

Model G5 - 5 Light Signal Sequencer

For Traffic Signals with one or two turn arrows

If you already have a 5 light signal and would like to put it on display we have what it takes to make it operate.  Until now one would have to buy a cabinet full of expensive electronics just to make one of these signals operate.  Now we have a very nice, compact control that will make these lights cycle just like they should.  This control is only 2 x 4 inches and fits neatly inside the case of your light and operates directly from the 120VAC line.  An easy to follow wiring diagram and hookup instructions are included with each unit.  All you have to do is mount the control board, wire the lights to it and connect your power cord.  Plug it in and it works!
 
 
 
 
 
Model G5 Signal Sequencer

Model G5 - 5 Light Signal Sequencer Specifications:

  • Total Cycle time adjustable from < 5 Sec to > 60 Seconds
  • Green arrow is on during last part of Red light phase plus first part of Green light phase (40% total cycle) 
  • Yellow Arrow is on during part of the Green phase (10% of total cycle) 
  • Green on 50% of total cycle
  • Yellow on 10% of total cycle
  • Red is on 40% of cycle
  • Green Arrow  40%
  • Yellow Arrow 10%
  • 5 Lamp output channels
  • 75W max. Lamp / channel,  Incandescent Only
  • 8 position screw terminal strip hookup
  • Wiring Diagram and Installation Instructions included
    		•
       

      The speed of the sequence is adjustable from 5 sec to more than 1 min !



     
     



    Lights to Go! - Price List
    & Online Order Form



     
     
     

    (C) 1999 Lights To Go! all rights reserved This page was last revised Jun. 15th, 2001