The P6 - 4 Way Traffic Signal Control, will not only operate a traffic light, it will control 2, 3 or 4 opposing directions of traffic.

If you already have a 3 light, 4 way signal you are in luck since we have just added the P6, a full 4 way signal control to our product lineup. This control will simulate the big cabinet mounted models while it is only 3x4 inches and fits easily inside the case of your light.

4 Way lights not only look great on display they are also very collectable, trading from $600 and up on the open market.  Until now one would have to buy a cabinet full of expensive electronics just to make one of these signals operate.  Now we have a very nice, compact control that will make one of these lights cycle like it should.

If you dont have a four way signal light this control can also operate 2 or 3 way light configurations (ie. 2 or 3, G-Y-R signal heads) set up to control opposing traffic directions.

Another great use is where you have two G-Y-R signal heads on a pole facing 90 degrees apart, this is true 2 Way operation.   These look great in the corner of a room.

The P6 features:
• A single control board 3 x 4 in.
• 4 x 0.140 in. mounting holes on 2.5 x 3.5 ctrs.
• Socket mounted, 8 bit microcontroller
• Digital cycle speed adjustment, w/ 4 preprogrammed time set selections.
• Six - 120 V Triac output channels each capable of 150W max. incandescent load
• All 6 output channels opto-isolated from the remainder of control.
• 6 colored LEDs on board to indicate the state of each output channel
• Coax DC power jack on-board, EXTERNAL AC adapter power supply included
• Integrated Power supply version also available,
  (Same as Model P10 control minus the Pedestrian Signal outputs)
• Dual 4 position screw terminal strip plugs for (AC) light connections.
• Separate 3 position screw term connector for preemption inputs.
• Selectable Red light overlap delay of either 0 or 1 second.
• Flash Mode Input forces the control into a flashing mode
• Will operate 2,3 or 4, Std 3 light signal heads. (A-B, A-A'-B, A-A'-B-B')
             This is 2, 3 or full 4 directions of traffic control.

Overlap input bit selects Red light overlap time of either 0 or 1 second. This unit is powered by an AC adaptor (9VDC). This is different from our other products that operate directly off the AC line. This means you will have to have an extra AC-DC adaptor.  This allows the control circuitry to operate in complete isolation from the AC line. This means there won't be any grounding problems hooking it up to other equipment.

There are two switches on the board that are used to set the timing modes.   This gives you four different sets of timing values you can choose between.  The standard timings are as follows:
 



 

Mode	Green A	Green B	Yel Time
Mode 1	10sec	10sec	4sec
Mode 2	15sec	15sec	4sec
Mode 3	20sec	20sec	5sec
Mode 4	25sec	25sec	5sec

Custom modes are also available for a nominal charge.   Send us an Email with your desired timings and we'll send you a quote.

Lights to Go!
Price List & Order Form

OR
Order Online with your Credit Card

For questions or comments Email: Lights to Go! 


---



Home Page


---

(C) Lights To Go! 1998     Revised 08/15/00